HOBO™ Energy Logger

• Automatic Communication of Configuration Information to Data Logger without Setup
• 12-Bit Resolution with Rugged, Outdoor Rated Weatherproof Housing
• 660 to 1070 mbar Measurement Range with ±3.0 mbar Accuracy
• 1.0 mbar Drift per Year
• 50 cm Cable Length

Includes (2) Cable Ties and (2) #8 Self Tapping Screws

• 660 mbar to 1070 mbar Measurement Range with ±3.0 mbar Accuracy
• Typical 0.6mbar Drift Per Year
• Needs Protection from Direct Exposure to Weather
• Dimensions: 1.75" x 1.875" x 0.625"
• Cable Length: 10 cm

Compatible with HOBO U30 Remote Monitoring Systems, H21-002 Micro Weather Station and H22 Energy Logger

• Ultrasonic Wind Speed and Direction Smart Sensor Has No Moving Parts
• Measurement Range of 0 to 92 mph (Wind Speed) and 0 to 359° (Wind Direction)
• Plug-in Modular Connector for Easy Installation
• Powered by a Built-in Solar Panel
• Compatible with Onset RX3000, U30, H21-USB and H22-001

• 0 to 5 Volts DC Measurement Range
• Measurement Accuracy: ±10 mV ±0.3% of Reading
• Resolution: ±1.221 millivolts
• Input impedance: 1 Megohms
• Ground connection: same for adapters and PC interface

• 15-Bit (2) Input Channels of AC Current or Voltage Measures TRMS
• Accurate Readings of Sinusoidal and Non-Sinusoidal WaveForms
• Accepts an Input Range of 5 mV to 512 mV
• 2-Wire Screw Terminals

• Easy to Open and Install with One Hand while Wearing Safety Gloves
• 333 mVolt AC Output at Rated Full Scale Current with No Shorting Blocks Required
• Low Phase Angle Error of ±0.50° from 1% to 120% of Rated Current
• ±0.75% from 1% to 120% of Rated Primary Current Accuracy
• 2.38" (W) x 2.40" (H) x 0.90" (T) with a 0.75" Window Opening
• 8 ft Conductor (White and Black), Twisted with 8 ft (2.4 Meters) Lead Length

Available in 5, 20, 50, 100, 200 and 250 Rated Amps

• 4 to 20 mA Measurement Range
• Measurement Accuracy: ±40 µA ±0.3% of Reading
• Resolution: ±4.93 µA
• Input impedance: 124 ohms
• Provides a Trigger Signal for Controlling Power to Attached External Sensors

• Split-Core Design for Fast, Easy Installation
• Internal Precision Burden Resistor
• Output: 0.333 Volts AC at Rated Current
• 8 ft Twisted Pair, 22 AWG Leads
• Operates from 50 Hz to 400 Hz

Available in 5, 10, 20, 50 and 75 Rated Amps

• Accurate Measurement of Sinusoidal and Non-Sinusoidal Waveforms
• Accuracy: ±1% (10% to 130% of Rated Voltage)
• Output Signal: 0.333 Volts at Rated Input Voltage
• Measurement Range: 0 to 150 Volts

• 15-Bit (2) Input Channels of AC Current or Voltage Measures TRMS
• Accurate Readings of Sinusoidal and Non-Sinusoidal Wave Forms
• Accepts an Input Range of 5 mV to 512 mV
• 2-Wire Screw Terminals

• Measures Air & Inert Gas Velocity and Ambient Temperature
• (3) Measurement Range Options: 0.15 to 1 m/s, 0.5 to 10 m/s and 1.0 to 20 m/s
• Output: 0 to 5 Volts DC
• Response Time: 400 ms
• Requires an Analog Input Option

• Measure Solar Radiation Light Levels Using Silicon Pyranometer
• 0 to 1280 W/m2 Measurement Range over a Spectral Range of 300 to 1100 nm
• Records the Average Light Intensity over the Pre-Determined User-Set Logging Interval
• -40°C to 75°C Operating Temperature Range
• Housing Constructed of Anodized Aluminum and Acrylic Diffuser and O-Ring Seal

• Measures the Light Range that Effects Photosynthesis (PAR - Photosynthetically Active Radiation)
• 400 nm to 700 nm Frequency Measurement Range with ±5 umol.m2/sec or ±5%
• -40°C to 75°C Operating Temperature Range
• Constructed of Anodized Aluminum Housing with Acrylic Diffuser and O-Ring Seal

Includes 3 Meter Cable Length

• Log and Records the Number of Contact Closures per Interval
• Plug-in Modular Connector
• 3.6 Volt Maximum Input
• Weatherproof PVC Housing
• Compatible with HOBO U30 Remote Monitors, HOBO Micro Station and HOBO Energy Logger

Includes (2) Wire Nuts and User Manual

• Log and Records the Number of Switch closures per Interval
• Plug-in Modular Connector
• 3.6 Volt Maximum Input
• Weatherproof PVC Housing
• Compatible with HOBO U30 Remote Monitors, HOBO Micro Station and HOBO Energy Logger

Includes (2) Wire Nuts and User Manual

• Precision Pressure Measurements in Compressed Air Systems, Water or Oter Gases and Fluids
• Accuracy: ±1% to 1.5% FS
• Connection: 1/4" NPT 305 Stainless Steel
• Output Signal: 0 to Volts DC, 3 Wire
• Available in 100 PSIG, 200 PSIG and 500 PSIG Pressure Ranges

Requires Analog Port Selection During U30 or RX3000 Series System Configuration and Use of a S-FS-CVIA when using the H22-001 Data Logger. When using a U12 or UX120 Series Data Loggers, this Sensor Requires a 0-5 VDC Analog Input Cable (CABLE-ADAP5) and External Power Provided by an AC Adapter (AC-SENS-1).

• New! AeroCone® Design for Better Measurement Accuracy in High-Wind Conditions
• Cost Effective way of Measuring Rainfall on HOBO Weather Stations
• Measurement Range of 0 to 10.2cm (0 to 4in.) per Hour
• Plug-in Modular Connector for Easy Installation
• Data Stored in Sensor & Automatically Communicates to Attached Data Logger (Sold Separately)
• Compatible with Onset RX3000, U30, H21-002 and H22-001

• New! AeroCone® Design for Better Measurement Accuracy in High-Wind Conditions
• Cost Effective way of Measuring Rainfall on HOBO Weather Stations
• Measurement Range of 0 to 10.2cm (0 to 4in.) per Hour
• Plug-in Modular Connector for Easy Installation
• Data Stored in Sensor & Automatically Communicates to Attached Data Logger (Sold Separately)
• Compatible with Onset RX3000 Series, U30, H21-USB and H22-001

• Measures Rainfall up to 5.0" (12.7 cm) per Hour and Accuracy of 1.0%
• Tipping Bucket Mechanism is Mounted on a Stainless Steel Shaft with Brass Bearings
• Constructed of Aluminum Housing and Collector
• Available in English or Metric Versions
• Includes 2 Meter Cable and Brackets for Post or Tripod Mount

• 12-Bit 2 Channel Sensor for Humidity and Temperature Measurements
• Automatically Communicates Configuration Data to the Attached Data Logger (Sold Separately)
• -40°C to 75°C at 0 to 100% RH Measurement Range
• ±0.25°C (Temperature) and ±2.5% (RH) Accuracy
• Weatherproof Environmental Rating
• 2 Meter Cable Length

• -40°C to 100°C (-40°F to 212°F) Measurement Range
• ±0.2°C Accuracy
• Automatically Communicates Configuration Data to the Attached Logger (Sold Separately)
• Stainless Steel Sensor Tip
• Cable Length: 2 Meters

• Measure Cold and Hot Water Flow Rates: 0.25 to 22.0 gpm
• Compatible with 3/4" Pipes and 1/2" and 1.0" with Step Downs and Step Ups (Sold Separately)
• Operating Range: 4.4"C to 82.2"C (40"F to 180"F)
• Dry Contact Reed Switch with 100mA Max Contact Rating
• 8 Digit Odometer, Meter Register May be Turned 360° for Easier Readings
• Lead Free Brass Meets the 2014 "Reduction of Lead in Drinking Water" Act Requirements

• True RMS AC Watt-Hour Transducer with Pulse Output Proportional to kWh Consumed
• Solid State Relay Closure
• Line to Neutral: 347 Volts AC
• Line to Line: 600 Volts AC
• Phases: 3
• Wires: 4

• Research Grade Plug-and-Play Wind Direction Sensor
• 0 to 355 Degree (5 Degree Dead Band) Measurement Range
• Average Wind Wind Direction in Sampling Interval
• Injected Molded Housing & Vane with Static Dissipating Base
• Long Sensor Life withStainless Steel Ball Bearings and Static Dissipating Housing

An Full Cross Arm (#M-CAA) or Half Cross Arm (#M-CAB) is Required for Mounting

• True RMS AC Watt-Hour Transducer with Pulse Output Proportional to kWh Consumed
• Solid State Relay Closure
• Line to Neutral: 277 Volts AC
• Line to Line: 480 Volts AC
• Phases: 3
• Wires: 4

• Uses 3-Cup Anemometer
• Plug-In Modular Connection
• Measurement Range: 0 to 76 m/s (0 to 170 mph)
• Accuracy: ±1.1 m/s (2.4 mph) or 4% of Reading Whichever is Greater
• Cable Length: 3 Meters

• True RMS AC Watt-Hour Transducer with Pulse Output Proportional to kWh Consumed
• Solid State Relay Closure
• Line to Neutral: 277 Volts AC
• Line to Line: 480 Volts AC
• Phases: 3
• Wires: 3

• True RMS AC Watt-Hour Transducer with Pulse Output Proportional to kWh Consumed
• Solid State Relay Closure
• Line to Neutral: 230 Volts AC
• Line to Line: 400 Volts AC
• Phases: 3
• Wires: 4

• Cost Effective way of Measuring Wind Speed and Direction on HOBO™ Weather Stations
• Measurement Range of 0 to 170 mph (Wind Speed) and 0 to 355° (Wind Direction)
• Plug-in Modular Connector for Easy Installation
• Data Stored in Sensor & Automatically Communicates to Attached Data Logger (Sold Separately)
• Compatible with HOBO™ RX3000, U30, H21-USB and H22-001

• True RMS AC Watt-Hour Transducer with Pulse Output Proportional to kWh Consumed
• Solid State Relay Closure
• Line to Neutral: 120 Volts AC
• Line to Line: 400 Volts AC
• Phases: 3
• Wires: 4

• 2 Sensor Set Measuring Wind Speed and Wind Direction
• Measurement Range of 0 to 100 mph (Wind Speed) and 0 to 355%deg; (Wind Direction)
• Calculates Average Wind Speed, Highest 3-Second Wind Gust and Average Wind Direction
• Data Stored in Sensor & Automatically Communicates to Attached Data Logger (Sold Separately)
• Compatible with Indoor and Outdoor Environments with its Weatherproof Rating

Requires a Li-Cor HOBO Full Cross Arm (Part #M-CAA) to Support Both Wind Sensors

• Replacement Parts for the H22 Energy Data Logger

Compatible with HOBO™ H22 Energy Data Logger

• True RMS AC Watt-Hour Transducer with Pulse Output Proportional to kWh Consumed
• Solid State Relay Closure
• Line to Neutral: 120 Volts AC
• Line to Line: 208 to 240 Volts AC
• Phases: 3
• Wires: 4

• Consumer-Grade UL-Listed Plastic 2 to 1 6-pin Adapter and 5" Extension Cable

• True RMS AC Watt-Hour Transducer with Pulse Output Proportional to kWh Consumed
• Solid State Relay Closure
• Line to Neutral: 120 Volts AC
• Line to Line: 208 to 240 Volts AC
• Phases: 3
• Wires: 3

• Used to Wire a WattNode Terminal Block Connected to a WattNode KwH Transducer and Voltage Terminals in a Circuit Breaker Panel
• Prevents Mis-Wiring to KWH Transducer
• Designed for Single Phase (120 to 277 Volts AC) and 3 Phase (208 to 480 Volts AC) Circuits
• 25°C to 85°C Temperature Rating
• Electrical Rating: IEC 60101-031 @ 1000 Volts CAT II, 600 Volts CAT III P2
• Indulsted Nickel Plated Brass, Sheathed Banana Plug Receptable
• 5 ft Cable Length
• Includes (5) Alligator Clips with Matching Cable (Black, Blue, Green, Red and White)

• Connect up to 6 Smart Sensors in a Water-Resistant Enclosure to 1 Sensor Extension

• Mounting Kit for Data Logger to Attach to Standard 32mm and 35mm DIN Rails

Compatible with HOBO H22 Energy Data Logger

• Male to Male Extension Cable
• Cable Length: Available in 2, 5, 10 and 25 Meters

Includes Female to Female Adapter

• Serial Interface Cable

• Permanent Mounting Using 3/8 Flathead Screws (Included)

Compatible with Li-Cor HOBO H22 Energy Data Logger